Bose
®
ControlSpace
™
Designer
™
Software User Guide
12 Chapter 1: Configure the ControlSpace Designer network
Use scan
The Scan button in ControlSpace Designer software can be used to
detect hardware on your local network.
Figure 1.14 - Scan button
Note: You should open a new project before using the Scan button. If you
press the Scan button with an existing project open, you may
experience a conflict that could change your system design
configuration.
Do not press the Scan button while you have an existing project open.
This may result in a conflict that can cause a change in your system
design configuration. Scan should be used with a blank new project only,
as a means to identify what hardware exists on the local network. When
ControlSpace Designer software completes the scan, the Project View is
automatically populated with the ESP-88s, CC-64s, and CC-16s that are
properly connected in your local network.
Comentários a estes Manuais